I turned a pen and pencil (rosewood) as a donation for my grandaughters preschool fund raiser, then decided they needed a case (maple). Comments welcome.
I turned a pen and pencil (rosewood) as a donation for my grandaughters preschool fund raiser, then decided they needed a case (maple). Comments welcome.
Skip,
Now why didn't I think of that. That's Brilliant. I'm gonna copy your design if you don't mind. That design is just what I need. Way, Way, Way KOOL!!!!!
Brian
Thats a beauty Skip. Cool idea. Well done.
Bernie
Never put off until tomorrow what you can do the day after tomorrow.
To succeed in life, you need three things: a wishbone, a backbone and a funnybone.
that is really a great idea - well done!
What's the diameter and height of the case?
Last edited by Greg Just; 01-26-2008 at 8:18 AM.
Perfect. it just dont git no better than that. excellent Skip.
John 3:16
Great idea Skip!
A few hours south of Steve Schlumpf
Thanks for looking and the comments. The case is about 7 1/2" high by 1 5/8" dia. The holes are 5/8" in the top area to accommodate the clips and 1/2" toward the base. I think the case could have been a little shorter and still held the set. My wife thought it was a pepper grinder.
As it was said, "Way cool! Cheaper too than the plastic thingys, and much more appreciated .
Bob
The most unique I've seen. Very nice Skip.
Really nice job on the pens and the pen case. Really good idea!
Really great Idea......... but won't it make your pocket sag????
I don't suffer from insanity; I enjoy every minute of it!
Nice work Skip.
[SIGPIC][/SIGPIC]Tom
Turning comes easy to some folks .... wish I was one of them
and only 958 miles SE of Steve Schlumpf
Skip
I really like that Idea.
I think you did a fine job and opened up
a whole new area for pen containers
great insite
ken
Epilog Laser, CNC equipment, Corel X3 & 4, Aspire
Fantastic idea. Hope you don't mind if I copy it or something like it.
Nice idea!!! I might try that one!