Heard all this rave about this tool so I thought I would try it. So today I got my Wixey digital gauge in the mail. I set it up on my tablesaw. I will explain what I did and if anyone has one maybe they can tell me what I am doing wrong. I set the divice on the table and zeroed it in and then placed it on the blade and it told me my blade was set at 89.7 degrees so I adjusted it. Now I took the device off the blade and set it back on the table and now the table needed to be zeroed again. I did this and placed back on the blade and now the blade is too far past 90. This went on for about 4 or 5 trys. I being not so smart thought if you set the device the first time moving it back and forth should get the same readings. Why does it not do it and what is the proper way to set this thing??? Has anyone else tried what I just described and if you did what was your findings???