1st Router table use...needed a jig to slide along the fence..
Drawer Dividers, Tues., slider jig.jpg
To run parts past a dovetail bit..
Drawer Dividers, Tues., 18 done.jpg
9 "rails", dovetail "Tails" on each end...takes 4 passes
Goal was to match this bit..
Drawer Dividers, Tues., need to match this.jpg
That will get used to mill a socket into the front edges of the Case's front stiles..
Router table does not have an insert, so..that slider jig was to keep the rail vertical, and NOT letting the part drop into the hole around the bit...I added a backer board and clamped THAT at 90 degrees to the table, made things a lot easier, and quicker...
Stay tuned, part 2 of The Router Table Follies is coming right up..