Had to replace a curvy one..
Drawer Dividers, ripped for width.jpg
Had enough "Leftovers" for that..
Drawer Dividers, Leftovers.jpg
The wide one on the bottom..isn't quite that wide, any more

The best 9 rails are all clamped up into a single block, for today....letting them "season" for a bit, after all that "stress".

Once these are all squared up, and equal length....this machine will be next...
Drawer Dividers, next up.jpg
Uses the same fence as the Tablesaw does...intend to mill a dovetail "tail" on each end...so that they can slide into a dovetail socket in the stiles..

That IS the plan, right now...been a busy morning..
Stay tuned..