Congrats on the purchase. I had to drill mounting holes to fit my uni... also, if you don't need the full 4 feet, considering flush mounting as the slider gets in the way sometimes.
Originally Posted by Troy Gamm
I know this is an old thread but I just ordered a Harvey slider for my 1939 Unisaw. I rebuilt the saw 30 years ago when I bought it at a used tool store where it was rusty and nothing moved. It is due for a good cleaning and lube job. It will be a bit before I can get it installed but I wanted to take advantage of the slider being 30% off.
Congrats on the purchase. I had to drill mounting holes to fit my uni... also, if you don't need the full 4 feet, considering flush mounting as the slider gets in the way sometimes.
Thanks. Not sure I will use the full 48" very often so I will most likely mount it flush. Would you happen to know off hand the max crosscut when it is mounted flush?
Troy, I believe it's 43 inches but I would double-check that.
Originally Posted by Troy Gamm
Thanks. Not sure I will use the full 48" very often so I will most likely mount it flush. Would you happen to know off hand the max crosscut when it is mounted flush?