Hey everyone so my Felder will be here in a few months. All of my current blades are 10", so I need some new blades since the Felder accepts 12" and needs the pins bored.
I've had great luck with my CMT blades (the good ones they make, not the cheaper ones) and I also use a really nice Ridge Carbide on my miter saw. I've seen some recommendations for Tenryu, but they seem to make 100 different blades, so a little confusing which one is their best line.
I currently use a rip to rip, general purpose for most things and an 80t crosscut to crosscut. I've seen a lot of people on the forums saying that a good general purpose with these more powerful sliders is all you need, but I'm a bit skeptical as my current 3hp Sawstop cuts wildly different with each blade.
Any advice would be greatly appreciated.