Hello all, I have had my new G0766 lathe for a couple months now and love it. I bought a HTC 125 chuck and am wondering if I may be trying to over tighten the jaws. After a few uses the chuck would slip when I was trying to tighten the jaws on a tenon so I took off the back and found that the snap ring had slipped out of the groove. I tapped it back into position and continued using the chuck trying to be careful not to tighten so forcefully. I usually tighten until it starts to grab then alternate on each socket to try and evenly tighten the chuck. I’m not cranking on with a two hand grip on the key just wanting to get it fairly tight. I had a talon chuck that I sold with a previous lathe that I never had this problem with. Just last night I had the same problem and had to fix the snap ring again. Just curious if anyone else has had this issue with a Hurricane chuck and to ask how you guys tighten your chucks.