Want to cut a 2" x 1/2" rebate & tennon on my shaper. Don't have a stub spindle. Biggest rebate head I have cuts up to 1 1/2" Looking for recommendation on a head that will cut a full 2" thanks!
Want to cut a 2" x 1/2" rebate & tennon on my shaper. Don't have a stub spindle. Biggest rebate head I have cuts up to 1 1/2" Looking for recommendation on a head that will cut a full 2" thanks!
Look into a 7" or 8" (200mm) groover? Assuming 1 1/4 or 30mm spindle. That'd get you 2"
Can you do it vertical?
I've had good luck with the Amana groovers as suggested by Mark. I don't think the rebate heads will go 2" deep. You could do multiple passes with a groover.
https://www.amanatool.com/products/s...r-cutters.html
I'm not sure, but perhaps you can get a head which allows you to pass material over the top of it, then you can cut tenons of any length, if gradually. Something like:
https://www.whitehill-tools.com/cutt...ads/070S00060/
I would use dados on saw for both operations, if I’m understanding Op question correctly. For a big bunch I might have to do something
a faster way.
The cmt 170mm grover will get you a 2"+ depth of cut.
https://factorydirectsupplyonline.co...BoCRYIQAvD_BwE
I have cut 2 inch tenons with the Amana 200mm groover.
https://www.amanatool.com/61358-inse...-1-4-bore.html