If I wasn't so damn old I would buy new, but has served my hobby needs and hope it will continue to do so.
Having trouble getting the fence square to the table. If you set it square and adjust the stop, then tighten down the two fence lock handles it moves the 90 set up, so you have to figure about how much it is going to move when you tighten it down etc... I have managed this in the past, but this time.... The square sitting on the out feed table is square to the fence when it is locked down, the square on the in feed table has a gap at the bottom.
So I don't think it's the fence, but could it be the in feed or out feed tables? Would adjusting the gibs compensate for this? It did not seem to. I do not know of a way to raise the back side machine way. I suppose I could lower the in feed table and shim it from the top, but this seems like the wrong way to go about it.
Appreciate any help.
Thanks
Brian