WIN_20210211_10_55_03_Pro.jpg
So I'm new to all this and I was playing around with the piece in the picture. It is a pocket cut around the letters and inside the box. The shaded area on the upper left is a few thou lower than the balance of the pocket. Originally, I had a toolpath at about .035 for testing purposes. That one left an area under the lettering a bit higher than the balance of the pocket. My second toolpath was at .07 and it went a little deeper in the shaded area. The equipment is a Sainsmart Pro ver 3018 (Yeah, I know it is a cheap piece), Vectric 2d, and Candle processor. Why the lack a consistent pocket floor?
Thanks in advance for your help.