Can a Bandsaw create Resawn Finish?

[Ira Matheny]

To get a 're-sawn' look to a board, use a band saw. However, you do not want to feed the wood into the bandsaw as you would do when normally cutting. You will want to drag the face of the wood backwards to the teeth of BS blade at an angle.

The resulting texture can be changed or altered by the way you do this thusly;
[1] adjusting the angle, [2] varying the speed at which you send the board against the teeth, [3] the tooth configuration on the BS blade.

You do not need to ruin a blade by bending teeth. [Or a power planer!]
You probably can replicate most any texture with any BS blade simply by trial and error using the 3 steps outlined above. Very simple.
Been there. Done that, Many times.