RECI W8 180W tube issue
Was cutting at about 40% power and after about six minutes the laser quit cutting.
It has been working great up until this incident.
Any suggestions on where to start troubleshooting this issue?
Thanks,
Chuck
RECI W8 180W tube issue
Was cutting at about 40% power and after about six minutes the laser quit cutting.
It has been working great up until this incident.
Any suggestions on where to start troubleshooting this issue?
Thanks,
Chuck
First I would make sure the water flow sensor is working and the tube is getting water. Then I would check all the door safety switches make sure their all making a connection.
If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine Oh wait its a 3D Printer my bad LOL
Lasercut 5.3
CorelDraw X5
10" Miter Saw with slide
10" Table Saw
8" bench mount 5 speed Drill Press
Dremel, 3x21 Belt Sander
Thanks Bert, I’ll check those out tomorrow.
chuck
Did you find the problem?
If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine Oh wait its a 3D Printer my bad LOL
Lasercut 5.3
CorelDraw X5
10" Miter Saw with slide
10" Table Saw
8" bench mount 5 speed Drill Press
Dremel, 3x21 Belt Sander
With Thanksgiving holidays, I have not got to the shop to further diagnose my issue.
hopefully later on today.
I do know that it is not the waterflow sensor or the door switches.
my power supply is showing the proper DC voltage in and voltage out but no amps out
Just from reading other such posts over the years, if you haven't yet, check both wires to the laser, more than one person has had that problem--
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now - fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
Thank you, I will be checking that later today and report back.
Chuck
The wiring appears OK.
It looks like my RECI P18 Power supply has gone bad.
this is a bit surprising because it doesn’t have a lot of hours on it. it’s only out pulling 1.8 mA and the RECI W8 laser tube requires 3 mA to fire it.
I have ordered a replacement power supply made by “light object”.
will report back when I get the new power supply.
Thanks for all the help,
Chuck
It appears that nothing is happening in the tube when I try to fire the laser.
chuck
Not surprising if your Pwr supply is not putting out.
If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine Oh wait its a 3D Printer my bad LOL
Lasercut 5.3
CorelDraw X5
10" Miter Saw with slide
10" Table Saw
8" bench mount 5 speed Drill Press
Dremel, 3x21 Belt Sander
That is a good indication that it is not the tube.
Shenhui 1440x850, 130 Watt Reci Z6
Gerber Sabre 408
You measuring residual current (at the black wire from the tube) or on the actual PSU Chuck?
You did what !
I fired the tube, Shut everything down and
then checked to see if there was any residual voltage at the negative side of the tube.
there was no residual voltage, suggesting the power supply what is the issue.
chuck
This method was suggested by Marco from “Light object’s”.