Originally Posted by
Bruce Wrenn
Just some off the cuff thoughts. Make the axle/spring assembly a removable unit. Build a tripod lift to elevate one end of mill to allow the assembly to be slid out, then lower mill to blocking resting upon the ground. Make ( I see you have a welder) your log arch wide enough to span mill, allowing for backing logs up over mill. When traveling, place mill in center of trailer, over axle, with a couple tension cables run over mill and to ends of trailer to prevent flexing. Just some ideas. You can take these ideas and a buck and get a senior coffee at Mickey D's, just be sure and have the buck. Shows what they are worth, doesn't it.