The motor to the pool pump is two years old (1.5 HP). Recently the shaft seal separating the wet side from the motor leaked. Apparently it was a long time before I realized it and had a chance to replace the seal. Afterwards the motor screams when in operation which has annoy the neighbor. The shaft also stops spinning almost immediately after the power is shut off whereas, before, it would spin a little before coming to a complete stop much like a table saw. I installed a new shaft seal today thinking that maybe that was the issue but there is no real change. At this point I am wondering if the chlorinated water corroded the bearings on the motor. If so, where would be a good place to have the bearings replaced? If not, does anyone know of a possible problem/solution as I would like to stop annoying the neighbor. A DIY is not an option because of other time commitments. Thanks in advance.