I've got a new 3HP PCS sitting on a trailer in my garage. I unboxed it, took all the parts into my basement shop, and got the main cabinet assembly rolled over onto the top piece of styrofoam (much nicer that they gave you instructions on getting it out like that vs when I flipped the top of my grizzly jointer to get it out of the crate).
Right now it looks like the center section is just a little too big and a little too heavy to get it into the basement. I'm thinking the easiest way to move it will be removing the top. It looks like if I loosen the adjustment set screws, unbolt the pivot point holder from the top, and then remove the 4 bolts holding the top I'll have it separated into 2 pieces. I sent sawstop support an email about this within the past week, but I haven't heard back, and now I'm under duress from the wife to get the garage cleared for her to park in it tomorrow night.
Anyone remove the top off the saw? Looks like afterwards the only thing I'll have to fully set up is aligning the miter slot to the blade, but the rest of the adjustments should hold to factory settings.