Straight lining boards the conventional way requires a straightedge at least as long as the board, and is a balancing act of keeping the board and straightedge tight to the saw fence, and through the saw together.
I've been straight lining my solid stock like this for quite awhile and thought I would share it with you. Special equipment? Just an upholstery stapler with ⅜" staples, and a few rips of ¼" plywood.
My only stapler had been a ¼" 18ga Senco that I got back in '92. I came up with this method when I acquired a 22ga upholstery stapler maybe 5 years ago. Both this stapler and my 23ga pin tacker are made by Grex and I've been very happy with them.
a-0.jpg
Staples: 18ga vs 22ga
If you don't have an upholstery stapler or pinner, they are a game changer in the work flow. Don't let the small size of these fasteners fool you, they hold. I can glue up a door or drawer in the clamps, shoot the joints together, and immediately pull the clamps. I can make up a whole kitchen's worth of doors or drawers using only 2 clamps...... I digress.
My sticks usually around come about 10' long. I use an 11' straightedge but I've been able straighten up to 13 footers with it. The straightedge is made from 6" rips of ¼" ply. 4" rips can bow laterally.
Unless you have access to oversized sheet goods, you will need to join two rips to make a straightedge over 8' long. Place the factory edge of the rips up against something straight, I used a door level but the factory edge of another sheet of plywood works great too. Bridge the joint on top with another 3-4' long rip of ¼". A little glue and a bunch of ⅜" staples and you're done.
a-1.jpg a-2.jpg
11' Straightedge.
How does it work? Essentially you're going to "attach" the straightedge to the board using ⅜" staples. The holes left by the staples are so small you'll have a hard time finding them even if you know they're there and are looking for them.
b-1.jpg b-2.jpg
Place the straightedge on the opposite side of the board you want to straighten.
b-3.jpg b-4.jpg
Set it so it is even at both ends.
b-5.jpg
Shoot it down using 3 staples, one at each end and one in the middle.
To be continued.......