I've had a Kreg K4 for a number of years and only use it occasionally.
However, I can't recall one successful joint that I have ever made.
For example, my latest failure was to build a gate for my chicken fence.
I used furring strips and tried to make it sort of like a cabinet face frame.
Using the recommended size screw was too short and used the next size which sort of held but a couple of the cross pieces pulled out.
I believe I have the jig and bit set properly; read and re-read directions and watched a ton of videos to see if I can figure it out.
I clutch down when driving screws
Why this matters is that I need to build a couple cabinets for my kitchen.
It would be really nice to use pocket screws.
If anyone has thoughts I'd appreciate it.
Thanks