I started with a HF 2hp collector then I pulled it apart placing fan and filter in attic above garage and adding a Dust deputy and trash can setup in the workshop all connected with 6" spiral. This worked fine until I added a hammer a3-31, the dust was too much for the system. So I started using my 6.5 hp shop vac with a 5 gallon bucket/separator top for just the hammer. The problem with this is the bags still fill up too fast. So I tried running it without the bag and now the bucket wont stop anything.
Before I pulled hammer off the dust collection system I must have clogged the ductwork somewhat because my suction is lousy. So I know I have to pull that all apart and/or blow it out.
My question is should I upgrade HF fan to something bigger or Should I keep the hammer separate?
If I do Upgrade it what should I be looking for?
If I dont how should I improve my setup on the jointer/planer by itself?