I agree with the Lightburn comments, I have been using it since the day came out, updates are regular and response time to queries is very fast. I haven’t used RDWorks at all since I got Lightburn.
I agree with the Lightburn comments, I have been using it since the day came out, updates are regular and response time to queries is very fast. I haven’t used RDWorks at all since I got Lightburn.
Shenhui SG350 fitted with a 60w tube.
Aeon Nova 10 100w tube.
Aeon Mira 5030 30w RF tube.
20w Fiber Laser.
50w Fiber Laser.
Located in the Isle of Man, which isn't in the UK but almost surrounded by it.
Retired Guy- Central Iowa.HVAC/R , Cloudray Galvo Fiber , -Windows 10
After plugging in your use from the computer to the laser. Have you run the software that sets up your driver. If so have you started artworks and tried simply drawing a line or square and sending it. And yes the needs to be an rd file. Of course you can do graphics through the laser networks program. The laser won't read a not along as it won't know what power speed etc
I know it’s a month old, but check the cable from the outer case of the laser chassis to the inward USB port on the controller. It’s usually just a ‘panel mount’ USB extension and it could be faulty or just fallen out.
Given that you can’t get it to read USB stick or be recognised by two different computers, that says to me that it’s a physical connection problem, or a broken controller, rather than a driver issue.