So I have this irritating "banding" going on, it shows up mostly on plastics. I have changed out the X belt and motor, and a new tube was done yesterday. I have also cleaned the machine very well lenses and mirror are all good. Alignment is fine also.
I have talked to epilog they say it is the belts "it's just that model". I have had this machine since new, and I am very sure it didn't do it when I got it, anyone else have this?
I can get by on most of the work I do , but on a large raster job it sure is annoying.
Attached is a pic of it on red cause it looks the worst..Untitled-1.jpg