I'm working on turning a pint glass (6'' deep, inner 3 1/8'', outer 3 1/2'') for an order I have. So far have tried:
- ascending forstner bits but you get a different center than the chuck
- boring a hole and hollowing tools but 6'' straight down is long for my Sorby hollower
- taking 1/8'' or 1/4'' of the edge at a time with my scraper
- using carbide tools
So much experimentation but havent found the way that is easily replicable and efficient. I'll be using poplar, cherry, and walnut do not super hard woods.
Suggestions? Thanks!!