Hey all. I just replaced my 9" Rockwell with a powermatic 64A table saw and I am in the process of setting it up. When I got it there were only two bolts attaching the tube guide to the front rail. I opened the manual and went to the depot. Alas all they had were 3/4" 1/4-20 bolts. When I tried to install them I found that they were all loose and would not tighten. The only thing I can think to do is drill out the holes on the tube and re-tap. Have any of you had this issue? How did you fix it? Thanks.
editted to correct Saw model: not 94A