What is the best sealer for plywood that will be used outdoors?
Thanks,
Jim
What is the best sealer for plywood that will be used outdoors?
Thanks,
Jim
Paint. It is better than varnish because the pigments in the paint help protect the paint and the wood from sunlight.
Use plywood intended for outside exposure -- exterior glue.
Be very careful to paint the edges thoroughly. Work the paint into any cracks or voids, and into the end grains. Edges are where outside plywood first fails.
It may depend on the intended end use. For example, I don't think paint would work for plywood that will be submerged. Stitch and glue boat construction like kayaks, canoes and sailboats use marine grade plywood sealed in epoxy and then coated with spar varnish or paint for UV protection.
This will not be submerged. I found some 1/2" birch plywood that is rated for outdoor use. The process I was thinking of would be to sand, seal, paint on the artwork and seal. What do you think?
Jim
Jim, I don't know . I've not seen or used any birch plywood outdoors. I do think there is a difference in out door under cover and outdoor in the rain. Years ago I thought good paint would protect almost anything outside. I'm no scientist but I've pretty much proved that good paint does not protect an inferior material for long.
First, use "treated" exterior grade plywood. Then paint all surfaces. If there are areas that you cannot paint for some reason then apply an exterior clear finish. if you need to use a water-based clearcoat, I would recommend General Finishes "Exterior 450".
"I've cut the dang thing three times and it's STILL too darn short"
Name withheld to protect the guilty
Stew Hagerty
If you are doing Artwork use MDO. It paints very well and has a special smooth paper face. It is used for outdoor signs. Dan
I've had little success with ordinary paint. For my recent project of replacing a trailer floor, after a lot of searching, ended up using a clear penetrating epoxy sealer with a topcoat of a pre-catalyzed urethane finish (a sherwin williams industrial coating product, about $200/gallon)-- basically treated it like a boat.
It's only been two years, but so far it still looks like new with no evidence of failure at the edges, so I'm optimistic. It's already much more successful than the prior paint.
"... for when we become in heart completely poor, we at once are the treasurers & disbursers of enormous riches."
WQJudge