So I'm doing a little back and forth today. I would like to pick up one of Whiteside's fancy compression, bearing flush trim bits and Im going between these two:
Whiteside UDFT5152 (LINK)
s-l225.jpg
Whiteside UDC9112 (LINK)
whiteside_ultimate_Combination_UDC9112__25089.1401833048.1280.1280.jpg
Which is actually a better route to go?
The first one seems nice because it has a longer cutting length and is skinnier (smaller cutting diameter) to follow tighter curves but only has bearings on one side which since I can put a template onto a work piece on either side shouldn't make that big of a difference.
The second one has a much larger cutting diameter which means it wont fit in as tight of curves but that should mean that itll have that much cleaner of a cut correct? It also has a shorter cutting length and costs more.
What am I missing here to help me make this decision? Thanks!