After 2 kitchens, 5 baths, and 2 laundry rooms I decided I've practiced enough to tackle some cabinetry for my shop. Been busy the last couple weeks. I've accumulated a ton of plywood and and used a lot of that up on these projects. There's some odd pieces in some of these such where, say, the grain runs the wrong way.
First, I rebuilt the Sysport Clone (which got a twin after that thread) to fit on a wall that hasn't been real well utilized for some time. I've been using more Systainers for other tools so my collection has grown further.
2013-11-16T21-11-36_2.jpg
Then I built some new cabinets for under my outfeed table. I used to have a couple metal toolboxes here which were pretty inefficient for space utilization. The drawer fronts are just prefinished maple ply. I rounded over the edges and probably should wipe some finish on them. My wife saw this today and said she wants the same in her craft room in the house so I'll probably be doing it all again.
2013-11-16T21-11-36_1.jpg
Then I started on a replacement for a hand-me-down metal office cabinet and an old cabinet from my master bath that were in my office.
2013-11-16T21-11-36_0.jpg
All to help eliminate a run of hand-me-down cabinets in one corner of my shop to make room to move this over from my dad's shop.
2013-11-16T21-11-36_3.jpg