Hey Guys, first post on here, been reading for a while.
I have a 2 month old epilog helix 50watt 18"x24" laser. It's primary use is to engrave/cut acrylic and thin woods.
Everything has run quite smoothly since purchase, until today. When raster engraving, I'm getting very fine lines in areas that contain no artwork that should no be getting engraved. Artwork is rather simple and this problem has happened suddenly, I have been engraving steadily since purchase with no issues. Photos show what I'm trying to explain.
Artwork is vector artwork at 60%K
Raster speed is 50/ Power is 95
Troubleshooting I have tried (based on epilog service call):
Cleaning optics
Aligning laser
Re-installing epilog driver
Has anyone see this before? Any suggestions appreciated!
image1.jpgimage2.jpg