Got my new router table mounted to the TS today, T tracks, miter track, Woodpecker PRL are all in. Just temporarily being held up right now, need to build supports. One will be a 12" x 12" tower immediately below the PRL to act as dust collector, another will be somewhat shallow drawers (10-12" deep) along the rear edge holding up the 'rear' extension. The PRL and my my PC OSS with the Woodpecker plate will store there, handy and ready to go.
The way I built it 'L' shaped was to be able to use it with the TS fence, auxiliary fence or Miter gage from the saw front, or to use it from the end with my Incra jig mounted on the rear extension. (hope that all made sense, front, rear, end all refer to the TS).
BTW: my 2nd experience with laminate -- used the old style mineral based this time, works much better, sticks better. I let it set longer, I think one of the problems I had with the water based is I got too much in a hurry and didn't let it set long enough.