I am wondering about an inexpensive dust exhaust fan for the lathe. No imagination about eliminating dust or curlies - just some dust reduction while sanding.
There is a hole in the garage wall behind the lathe - about 10" x 14". I am looking at $40 to $200 solutions.
I am not starting from scratch. I have the Delta 50-760 dust collector attached to 4 power tool in the middle of the room, a Jet Air Filtration unit, a broom and a couple of shop vacs. I also wear a 3M half facepiece respirator. The Delta is too far away to run a duct efficiently to the lathe.
I do not like too much excess noise.
Any suggestion?