I have had a Chinese CO2 laser (CNCOLETECH) Model 9060 for two+ years now. I have complained over that time to Shirley (who monitors this forum) that the apparent velocity of my X & Y heads differ significantly. Their solution was that I should draw a square on the software and one on a target piece and run the program. Using a micrometer, I should make arbitrary corrections to my X or Y move commands until they "seemed" equal. I complained that the XY table is a precision unit made of standard components in a production line. It has X & Y input values of up to eleven places behind the decimal point and that the pencil and ruler method of setting it up was unacceptible to me. Several more requests for the XY values which they use to set up their Model 9060 Laser Engravers before shipment have been made but there are no more reply emails.
So I was wondering if there was anyone out there who has a Model 9060 Laser Engraver from COLETECH that I might compare software values from my XY Options page to see how far my machine might be off?
Please give me a call at (360)666-1883 if you have one. Art