Yesterday I finally got around to installing the capacitor that I bought from TEDSS. That seemed to solve the problem and the BOSS is up and running again.
Yesterday I finally got around to installing the capacitor that I bought from TEDSS. That seemed to solve the problem and the BOSS is up and running again.
I had a problem with my BOSS sander similar to what's been described in this thread. I took out the run capacitor and noticed the bottom had ruptured. An ohmmeter across the leads showed zero (not infinite) resistance, so I knew the capacitor went bad. I wasn't sure if this was the root cause or a consequence of the root cause, but I decided to replace the capacitor anyway. A Google search showed that TEDSS had a very similar capacitor. (The link ended up being the same link from earlier in this thread.) I went ahead and ordered from them. I installed it last week and so far so good.
When I researched this problem on the Internet I noticed several forums discussing problems with the BOSS' motor and capacitor. My guess is that the motor gets too hot because the ventilation isn't very good. There are vent openings directly under the sanding table, and 1/8" openings around most of the bottom of the base, but when I did a little smoke test I could hardly detect any air flow through the vents. It might not make much difference, but in the future I may try putting the sander on some 2xs to help get more air moving beneath it.
Thanks to everyone for their comments on this thread.
this question doesnt pertain to any capacitors but i figured since there are so many BOSS owners here you could answer something for me?
has anyone come up with a trick for loosening the top bolt holding the sanding drums or do i just have to keep flipping my sander over to
put the allen wrench in the bottom hole? why would any company make it so difficult to change out a drum?
there should be a rod or something to lock the spindle that comes in from the front or side?
any ideas on this?
As I recall, I just hold the drum with one hand and loosen the retaining screw (left-hand threads??) with the other. I don't seem to need to tighten it up very much and can always loosen it this way. It never has come loose in operation. Hope this helps.
Kevin
New BOSS owner here, but I agree w/ Jerry S - just hold the spindle in your hand while you use the socket wrench. The threads are left handed.
Jim
This worked for me.
250VAC 16uF CBB60 Motor Run Capacitor 16 uF/MFD 250 VAC 250V AC 30x65mm UL Listed (25/70/21) https://a.co/d/6caHe74
as long as its rated at 16mF, the rated voltage wont matter as long as its OVER your nominal voltage (120v etc) , 370 and 440 volt capacitors are easier to find usually - its an everyday item in HVAC work. If you have a multimeter that reads volts and amps, and are comfortable with live voltage, there are videos and a formula to check the capacitor while running to verify its bad. I have ran across numerous ones in my work that test good with a meter on the mF setting, but are actually bad when verified this way