[OP]
Member
I’ve video taped and blogged about my Holtzapffel Workbench at my blog, TheDustyDeveloper.com. There is nearly 2 hours of video (linked from youTube) in case anyone is interested. Its made from Ambrosia Maple and a little walnut just for kicks. Its small, only a little over 5 ft and the vise can handle about 18” between the screws.
Thanks
Steve
Last edited by Bruce Page; 09-20-2011 at 10:50 AM. Reason: Removed active link. Linking to personal websites is not allowed per the TOS.
Member
Way to go Steve, it looks great and should serve you very well.
Best Regards,
Gordon
Member
Steve, that is one fine looking bench. BTW, I watched the last of your videos (you did a great job on that, too), and it looks like that vise is going to be a pleasure to use.
How much does your bench weigh?
[OP]
Member
Thanks!
Not really sure what it weights but its probably a couple hundred. I put it on plastic furniture pads to move it on the concrete floor and just left them under there. I can plane against the plane stop and it doesn't move even on those pads...the soft foam on the pads helps with the unlevel floor too.
Reply With Quote
