Hey Guys,
I some suggestions on attaching wood aprons to a stainless frame to make a table. The Stainless is 1.25 square tubing, about 1/8 inch thick. I have tried to attach a picture of the piece with the wood friction fitted. This is a especially difficult task because the tubing isn't square from top to bottom and some of the tubing has a slight twist so every wood piece is taylor cut to fit between the tubing.
The best idea I have had so far is to plow a couple of grooves into the wood aprons to loosly accept a threaded stud which I will put into the SS tubing. Because the tubing isn't square to each other I figured I will adjust the wood to split the difference in the reveal of the tubing and then encase the threaded stud in epoxy.
I would be very greatful for any suggestions
Jason