Couple pic's of the workbench progress. As you can see, the top is currently 6" wide laminations that need to be laminated together.
The top is 71" x 30" x 3 1/2" deep. The tool well is 42 1/2" x 6" centered. Open the doors to two slide out trays, will show them in finished pic's.
My question is, should I glue laminate the five sections together or should I drill them and tie together with threaded rod, washers and nuts? If threaded rod is recommended, how many? I'm thinking two on each 30" end, two or three each side of the tool well. What do you think ??