The camera went to the shop today to take some pictures for a different thread.
Then my mind wondered over a couple of other things that have been mentioned recently.
One was using a router plane like a marking gauge that someone mentioned. That came in handy today for marking from an edge that is not square to the face. A wheel gauge would also work OK, but the router is being used to smooth the bottoms of the joint so why not?
Router Marking Gauge.jpg
Another recent post mentioned there not being much use for a 2" chisel. Well, that is likely true for most of us, but sometimes there are bigger pieces of lumber involved and the bigger the lumber, the bigger the chisel.
2" Chisel.jpg
Just for fun,
jtk