A neighbor my wife knows is remodeling the kitchen. The plans were for the re-modeler to completely demo the kitchen, i.e. everything goes to the landfill/incinerator. I volunteered to "re purpose" the cabinets in my garage/workshop (somewhere around half a 2 car garage is my workshop).
So, now I'm the lucky owner of nearly 18' of cheap, but usable maple fronted base cabinets and 8' of uppers. Since the price was $0, I'm pretty happy (insert stealth gloat).
My problem is that my garage (and I'm sure many others), has a footing that rises above the floor by varying amount, but usually at least 2" and generally less than 3". Then a +/- 4" step to the 2 x 6 PT sill plates, then a step to the 2 x 4 construction walls. I'm not sure what is the best approach to installing these cabinets. My thoughts so far:
1. Notch the cabinets so they will fit against the wall. This will work as long as the notching stays below the bottom self of the cabinets. And this approach doesn't work for a cabinet in a corner very well.
2. Mount (set) the cabinets on the floor. This leaves a space greater than 6" between the wall and the back of the cabinets which might be nice for DC piping, but I'm not there yet. And if I go this route, I'll still somehow need to periodically attach the cabinets to the wall anyhow. And then I'll have to build some sort of bracing for the uppers out from the wall or they will be (mostly) impossible to reach into.
3. Set the cabinets up on the footing, but still not against the wall. I'm not sure there is any advantage here.
4. Set the cabinets on the sill plate and mounted to the wall. Disadvantage - seriously raises the cabinets (hence, counter-top) height and I believe will need adding additional bracing between the cabinet bottoms and the floor.
Are there other possibilities/solutions? I've seen pics of others' garage based workshops with cabinets. What have you seen or done?
Thanks,
psh