I am scheduled to demo at the OC fair tomorrow and plan to use a Jacobs chuck in the head stock. I need to use a draw bar for this, so my question is: what is the spindle length including the hand wheel?
Thanks
I am scheduled to demo at the OC fair tomorrow and plan to use a Jacobs chuck in the head stock. I need to use a draw bar for this, so my question is: what is the spindle length including the hand wheel?
Thanks
Last edited by Larry Marley; 08-10-2010 at 2:10 PM.
Just cut off the parts that don't look like a bowl...
Hi, Larry:
I just measured mine. From the nose of the spindle to the outer surface of the handwheel is 13 1/2". The inner surface of the handwheel where a 1/4" or 3/8" fender washer would seat is 1 1/2" less, so 12" from the nose of the spindle.
Take care
Bob
Perfect!
Thanks Bob
Just cut off the parts that don't look like a bowl...