I had a short ~3ft piece of 4/4 x 6" walnut with a big knot hole in one end so I thought I would make use of a piece of it. So, for your critique and musings here is a small walnut coin bowl. You may have seen my previous post showing the effect of a bad catch when turning it. I did some gluing and some patch work and I think It turned out pretty decent.
Stats:
Nicely figured Walnut
One coat CA Finish then Triple E and finally wax.
Brass Filings and epoxy inlay
Diameter - 5.5 Inches
Height - 1 inch
If you look closely at this photo you can see the hairline crack where I glued it back together.
IMG_1726.JPG