Before Picture
After picture.
I really like the way it turned out,a lot flatter/straighter, and after waxing it's slipperier than the old face.
JEFF
Before Picture
After picture.
I really like the way it turned out,a lot flatter/straighter, and after waxing it's slipperier than the old face.
JEFF
Looks nice. What were the faces, UHMW?
Sweet. My Bies faces have been very usable but not as nice as I would like. Thanks for the pics.
"A hen is only an egg's way of making another egg".
– Samuel Butler
Great idea. Should've gone with green corian to compliment that Grizzly green!
Coolmeadow Setters...Exclusively Irish! When Irish Eyes are smiling....They're usually up to something!!
Home of Irish Setter Rescue of North Texas.
No, I'm not an electrician. Any information I share is purely what I would do myself. If in doubt, hire an electrician!
Member of the G0691 fan club!
At a minimum, I'm Pentatoxic...Most likely I'm a Pentaholic. There seems to be no known cure. Pentatonix, winners of The Sing Off, s3.
Great idea. How do you cut Corian?
I just cut it like it was wood,ran it over the jointer first then ripped it to width. Drills nice. You want to make sure to smooth over the edges because after cutting the edge is pretty sharp.
I am in the process of making some ZCI inserts with it.
Will report on that when I'm finished
JEFF
It would be great if you'd send me a couple to try out on mine before I offer an opinion. Seriously, those look great and you did a bang up job making them. Cudos!
t
[SIGPIC][/SIGPIC]
How were the blades on your jointer after running the corian through it?
And what about just jointing the original polyethylene and putting it back on?
Hi Jeff,
I have no idea how strong/bendable corian is, but you may want to check its strength before making a ZCI with it. I've heard of cases (perhaps apocryphal) where something caused the blade to grab the workpiece and pull it down through a weak homemade ZCI). And since hands often follow workpieces....
---Mike