OK so I finally have my new shaper setup, power is run and it is connected to the dust-collection system. So I can turn it on and actually use it! I have never used a shaper before so I need some suggestions on an initial set of cutters to acquire. It is a 5HP model with a power feeder & 1 ¼” spindle and initial use is for cabinet doors & drawers.
So for you shaper gurus –
What cutter shapes do you end up using the most?
What vendors should I consider buying from?
Steel, Tantung or Carbide?
One piece or replaceable cutter system?
Any/all other suggestions appreciated…