-
Other than the installation manual, no other instructions for the fence.
I thought about doing what you talked about, that will ensure the tube is straight. There's one sticky spot on my fence. What did you use to index? I used my putty knife before.
As far as the table goes, using my cheapo Sears straight edge, I only have one spot where I can slip a single sheet of paper in (.0030 according to my calipers). Good enough for me. My wood certainly isn't that flat. I started at the front and worked my way back. Clamping it is a good idea, but I didn't have to, I just used a flat piece of wood and light taps with a hammer.
Next I'll try to tune up the fence like you did Paul. Thanks for the tip.
Just for fun I put the calipers on the rails- 4.2mm, which probably accounts for the paint finish. The "T" part of the fence was 6.2mm. The main tube is probably 2mm, I can't get the calipers on it without taking it apart. I don't think it really matters though.
I need to get some finish on my boxes before I do any more work on the saw.
Last edited by Rob Price; 04-03-2009 at 1:06 AM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules