I finally have to swallow my pride and get some opinions. I bought a new Grizzly Tablesaw a few months ago and all the set up went fine except for setting the adhesive ruler on the fence tube. I expect to add a sacrificial fence that slides over the entire fence and can't whether decide to apply the ruler with or without the sacrificial wood face. Are there are any thoughts or opinions on where to set the zero? Such a simple decision yet I have waffled long enough...
If you are using a sacrificial fence, recommended designs and/or pictures are more than welcome. I found this good one already but there can be no shortage of ideas to stew on. http://www.sawmillcreek.org/showthre...rificial+fence
Thanks in advance.