Hello! I have been trying to figure out how to create an inlay on my CNC router. I can't figure out what I'm doing wrong, but am guessing maybe it's the bit I'm using? I am using a 60 degree v-bit. I have attached two pictures, the first one was pine inlayed with cherry. I then realized maybe the pine being too soft would have a lot of movement, so did the next one with maple inlayed with sapele. I also scaled it up to see if my details were too small on the initial attempt. For the female half my start depth was 0" and flat depth is .25". For the male portion start depth is .1 and flat depth .2".

Any ideas what could be causing the gaps in certain areas of the material?image_67200769.jpgimage_67533569.jpg