Merry belated Christmas everyone!

So I recently damaged the 1/2" honeycomb table in my epilog Mini via fire, and ordered a replacement directly from Epilog. They took down my serial number, and year of manufacture (mine is a 2006 Epilog Mini 24) but ended up sending a honeycomb table that is 1" thick instead of the 1/2" one that my machine needs. This 1" thick frame doesn't fit under the spring loaded rulers in the machine.

What do you all think? Should I try to get a replacement from them or is there some sort of an adjustment I can make to fit the 1" frame fit within my lasercutter?

There are a couple of photos below - one is how the 1" frame sits under the rulers, and the other showing the comparison between the old damaged one and the new 1" frames.

IMG_9703.jpg

IMG_9702.jpg

Thanks all!
------------
0l0id