Hello,
Does anyone have an idea on this situation with the FS 30. When in jointing mode everything works as it should. However, when trying to use the tool as a thickness planer then the machine will not turn on. I have looked all over for a safety switch or something that keeps the motor from turning on. But to no avail. I purchased this machine used a few years ago. It has worked fine in both modes until yesterday. I have a feeling that it is something obvious staring me in the face, but for the life of me I cannot seem to figure the problem. The manual leaves a lot to be desired. There basically is not trouble shooting section in the manual. I attempted to speak with a tech representative at SCM and was told I would need to register the machine at a cost of $850.00 to speak with a representative. Yes, $850. Thank You.