Results 1 to 12 of 12

Thread: How do I make these cuts?

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 09-02-2023, 11:36 AM #1
    Mark Gibney
    Mark Gibney is offline [OP] Contributor
    Join Date
    Mar 2014
    Location
    Los Angeles
    Posts
    1,396

    How do I make these cuts?

    How do I make the 40° angle cuts on this board?

    The boards will be milled to 1 1/4" thick.
    After I trim the angles shown on the edges I will then mill a cove on one face.

    Screenshot 2023-09-02 at 8.31.03 AM.jpg

    I can rip the 50° angle the normal way - tilt the blade to 50°, clamp on a sacrificial fence, tune in the fence position and rip the boards.
    The 40° rip is what has me stumped right now.
    My saw is a right-tilt Unisaw.
    What do I do?
    thanks, Mark
    Last edited by Mark Gibney; 09-02-2023 at 12:21 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules