I want to set up an outboard fence for my shaper to make some moldings. This is the first I have done this but I am aware of the dangers of kickback. I plan to use my power feeder but am not sure how to position it. Normally I position my feeder so there are two wheels behind the center of the cutter head and one in front to ensure there is always support while the cutter is in contact with the wood. Of course, with the outboard fence this is not possible, and it looks as though I have to choose putting the feeder on the infeed side of the cutter head or on the outfeed side. The opposite feed side could be held with a feather board. I am looking for input as to what others have done, and if possible some pictures. Any advice is most welcome.