I used waterlox satin finish, original, on a piece. It sat for over two weeks before I placed anything on the surface. When I did place a ceramic candle holder with a felt bottom left a ring on the surface where it made contact. I e-mailed chip at waterlox and he was very helpful, but did not solve my problem. He tells me it should cure 98% in seven days. So I lightly sanded with 320 and applied an additional coat of finish. It set for two more weeks and I put stuff back on the surface this morning. By tonight it had marked the surface again. It looks crinkly, uneven and rough where the felt made contact with the surface. Even where the feet on a small lamp sat made the same impression.

Could I have applied this so thick that it still has cured out at this point?

Thanks.

Brian