I know this subject has been beaten to death, and I have researched a lot of sites and table saws, but I am in the market for a small shop table saw. I have a Delta light weight saw now. In looking at the job site saws, I don't think there are enough advantages in getting one compared to what I have. I am looking for a contractor table saw with a smaller profile as I am installing it in a rolling cart. I looked at Delta 5000 series but the profile is just to big. I don't rip large sheets. I am mainly cutting picture frame material, and for small shelving cuts. It sucks that there are no real woodworking retailers in my area where I can go and compare. Any thoughts?