Has anyone down-sized the motor in a BIG slider? Say dropped a 10Hp motor out and installed a 5Hp..??

I am casually looking for a used sliding table saw. Looking out to ~500miles from me, I see very few (=0) in a 'consumer' size: <=5Hp, 220V, single phase. But I see several industrial sized units: >7.5Hp., 480V, etc.. I don't need 10Hp, or even 7.5Hp - and really don't want to try to supply that much power via a home shop electrical service.

I am not concerned about the electrical reconfiguration inherent to such a swap, but as this is a new machine to me, I am wary of any potential mechanical pitfalls to reducing motor power.

TIA.

(I have considered a VFD and just dropping the allowed motor amperage, but want to consider the motor swap as well.)