I have a garage based shop that by necessity for family life has to be mobile, meaning I move machines into and out of use positions as needed. I recently found a local seller who has an old PM FS305 and Pm180. Both are in good condition with Byrd heads. Well cared for. The jointer (900lbs) will largely be stationary but I would have to move the planer into and out of position. It weighs 1250lbs. I was thinking of bolting one or both onto machinery rollers (strongway or something similar) but I don’t know how difficult it is to push and pull this kind of weight around. The floor is concrete with a slight slant. My goal is to do this without injury, if that’s not realistic then I’ll have to go with a smaller planer. I’m open to suggestions and critiques. Thank you.